Individual LED Control

Up to date as of version 1.6

Table of Content

• Overview
• The Setup
• Sending Colors

Overview

In this panel you can control an individual LED.

The setup

The setup in this panel, is the same as was put in the Configure Setup section. However the hardware IDs are now shown as buttons.

Sending Colors

Down in the bottom, are located track bars to change the color that you want to send. After you have selected your desired color, you simply press the buttons in the series. This will make the button the given color, as well as sending that color over to the actual LED. You can also color an entire strip, by checking the checkbox down in the button, then you can again press on an LED, and the program will instead send that color to that entire series strip.